How It Works
The Power Saver is power factor correction device, in one word a CAPCITOR
Power Saver is suitable for Australian and New Zealand.
No electrician is required. A voltage surge suppressor is built in to adjust current wave shape which helps to protect electric appliances and increase their service life.
The Power Saver changes the power from incoherent to coherent, in other words it takes out all the peaks and troughs, then sends a smooth current through the loop of power point circuits it is plugged into.
Power Saver designed and engineered in Australia for the purpose of reducing electricity consumption by saving on power. Stabilises voltage, reduces current and reduces power wastage so that electricity is saved.
Only 1 POWERSAVER UNIT Needed per circuit to effect savings from all your power points!
For best results use one unit per circut. ie: Small home may need only 1 Power Saver, 3/4 Bedroom home may need 2 -4 Power Savers for maximum savings. Check your fuse board. You will see under each fuse switch labels. There will be lights, hot water, power. Power is what you are looking for. Count how many power fuses you have, these are the number of Power Circuits you have installed within your home. You will need one Power Saver per Circuit NOT per power point.
INSTRUCTIONS
Units and small homes (typically 12sq)
- Simply plug your Power Saver into the nearest power point to your meter box or on your heaviest load circuit ( you may have one just one power point circuit for example - a television, computer system, kitchen appliances.
Larger Homes, Offices, Buildings
- Plug your 1st Power Saver into the nearest power point to your meter box.
- Then one Power Saver in each of your other power point circuits to gain the savings.
90 Day Money Back Guarantee if your savings achieved, are less than 10%
